ISO 9001 Factory YEM015SJ Single Phase Electronic Energy Meter Din Rail LCD Display Power Meter

Model YEM015SJ single phase electronic DIN rail active energy meter is a kind of

new style single phase two wire active energy meter, it adopts micro-electronics

technique, and imported large scale integrate circuit, uses advanced technique

of digital and SMT techniques, etc. It has its completely independent intellectual

property rights and minimum size. It has already passed the test of the

international authority KEMA. The meter completely accords with relevant

technical requirements of class 1 single phase active energy meter stipulated in

international standard IEC 62053-21. It can accurate and directly measure 50Hz or

60Hz active energy consumption from single phase AC electricity net. This meter

has white backlight source eight digits LCD displays shows the active energy

consumption. It has following features: good reliability, small volume, light

weight, specious nice appearance, convenient installation, etc.

1. 35mm standard DIN- rail installation , complying with standard DIN EN50022.
2. Bipolar width (Modulus 17.5mm), complying with standard DIN43880.
3. Standard configuration 7+1digits display (9999999.1kWh) by white backlight source LCD. May select7+1 digits display (999999.1kWh) without backlight source general LCD, (Product Configuration code is SK).
4. Standard configuration pulse output passive (polarity),May select distant pulse output passive( nonpolarity). And contact with all kind of AMR system conveniently,Complying with standard IEC 62053-31 and DIN 43864.
5. Two LED instructions power supply state (green) and signal of energy impulse (red).
6. Automatic detection the direction of the flow of load current. And instructions on LCD (when display HELP 1 on LCD, that is meaning the direction of the flow of load current reverse).
7. Single direction measurement single phase two wire activeenergy consumption. It is nothing with direction of the flow of load current. Complying with standard IEC 62053-21.
8. Directly connect operation, there are two types wiring you may select. Standard configuration type S wiring, may select type U wiring (Product Configuration code is UJ).
9. Extension terminals cover,in order to protect to use safety.